Rearviewsafety RVS-7707721 Manual de usuario

product manual installation instructionsReaR View CameRaSyStemS© 2009-2013 Rear View Safety, Inc.

10Audio works on two ports of multiplexer and positive triggers must be triggered for audio to operate. #3 Port labeled “backup” (blue trigger) #2 por

11camera diagramIn some models, to remove gridlines from camera, cut green wire

12multiplexeror DVD

13positioning

14monitor dimensionsSome Modelspowerpowervideo selectdown/upmenumirror/normalimagemenuchannelselection with sun shadedown upmirror/normalimage

15camera dimensions

16Camera Picture Elements Gamma CorrectionImage SensorLensView AngleSync SystemInfra-red distanceUsable IlluminationPower SourceS/N RatioElectronic I

17TFT LCD Digital Monitor Screen SizeDot Resolution Display FormatDisplay BrightnessViewing AngleVideo InputVideo SourcePower SupplyPower ConsumptionO

18splitting & installingthe embedded monitorInstalling sun shield: put shade cover on the display. Installing back cover: Put the monitor with sha

19troublshootingDo a hard reset, unplug all cables and power cables from multiplexer (silver box) leave out for 1 minute and then re-connect them.Chec

2Introduction ... 03Safety Information ... 04Instal

201 Year WarrantyThis warranty is void if: defects in materials or workmanship or damages result from repairs or alterations which have been made or a

1680 Atlantic Ave #301Brooklyn NY 11213800-764-1028 www.rearviewsafety.com© 2009-2013 Rear View Safety, Inc.

3introductionPlease read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s

4safety info.Place the monitor away from direct sun light, heat, water or moisture.This product is made with precise electronic components. Handle wit

5before you begininstallationStep 1 Choose the monitor and camera locations. Step 2 Install all cables in vehicle, when necessary a 0.8 (20mm) hole sh

6 installation diagramDC12V(RED)Ground (black)Port #3 (blue)Port #2 (white)Port #1 (yellow)Power Cable

7Camera1. Attach camera bracket close to rear marker lights, centered on vehicle.2. Attach camera to bracket using screws provided and adjust the ang

8installing ofthe monitorOn Select ModelsConnection of U Bracket Connection of Flushmount BracketFigure 1.1 Figure 1 .2Figure 1.3 Figure 1.4

9Note: IF CONNECTING POWER DIRECTLY TO BATTERY, THE CAMERA IS ALWAYS ON AND THEREFOR CAN DRAIN BATTERY, THEREFORE ITS RECOMMENDED TO CONNECT POWER TO